Popping and cracking is driving me crazy [Solved]

[Blackbrook]

I have to amplify the Input with 40dB, yours are at 0dB or 5dB. Try to increase it or even calibrate (whoch should increase it automatically).

Cheers,

Steve

@Stelios: Thanks for converting!

[Jim B]

I converted them to .jpeg so you can see and give some help..

Thanks mate, some Karma is coming your way

[sfronti]

Thanks a lot!!!

Stelios, Greece

[Bigcic]

Well I did try to turn the input up to 40 and this did NOT work. This made it the worst sound since I got it. Well I have tryed everything and I am pretty sure the input 3/4 does not work right. I going to have to do something or look for another software.

[Blackbrook]

I have read this thread up and down, the pictures of the screenshots you made are gone and I can not see which audio interface you are using, you never mentioned. Please provide more info!

Cheers,

Steve

[sylMV]

Well I did try to turn the input up to 40 and this did NOT work. This made it the worst sound since I got it. Well I have tryed everything and I am pretty sure the input 3/4 does not work right. I going to have to do something or look for another software.

Use calibration process on both inputs to have good gain values.
If you're using a phono preamp, you should be around 0dB, if not around 40dB.
Then check both players are in "Speed" mode and your latency is 256 samples @ 44100Hz.
There shouldn't be an issue with this config.

[Bigcic]

I used the calibration process and both tables are around 0db and latency is ar 256 sample rate. It is also in speed mode and the 3/4 input output to the right turntable still sounds distorted when slowly backcuing. The left is fine and always has. The problem is the 3/4 input going to right turntable. I have done everything from checking wires changing wires. Putting new needle on. Switching turntables and it always leads to the 3/4 input

[sylMV]

It definitely sounds like a defective soundcard, but you wrote you had no problem with the Cross 1.5... that seems strange.
Can you test back in 1.5 ?

[Blackbrook]

And in addition to what Sylvain wrote please try to switch both turntables to see if "the error changes the deck" too. If so it is related to your turntable.

Cheers,

Steve

[Bigcic]

I already switched decks to see if it was one of my turntables causing the issue but it does not matter. Only 3/4 input causing the issues. Has nothing to do with which deck is hooked up