Soundcard setup confiq..?

[TuomasH]

Hi! I have mixvibes U-mix44 soundcard and Cross DJ Pro. Everything else works but outputs... Outputs goes in mixer only in one channel so mixer is usefull. So problem is that Cross shows that outputs goes to "U-mix44 sound device 1/U-mix44 sound device 2" Theres like two channels in one, so how can i split them or is there anything else that i can do..?

[TuomasH]

file:///C:/Users/Tuomas/Desktop/N%C3%A4ytt%C3%B6kuva%20(4).png

Theres picture that shows inputs but its same in outputs

[RoJeC]

The link to the file doesn't work because it's your local file...

Most used setup would be to select Dual Stereo mode. Output 1=1/2,output 2=3/4.

Then in Cross screen check if the position of the Mix knob fader is fully left. If it is not left also the sound of the Main is send to the Cue.

[TuomasH]

Routing mode doesnt do anything, hopefully you can see the picture now https://www.flickr.com/photos/139579943@N06/

[RoJeC]

You opened the listbox at the inputs. Just like the outputs 1/2 are the mono signals, so you need 2 for stereo.
your outputs are in the right 'column'. I can't see what you selected in asio4all. As mentioned normal setup is Dual Stereo. Then you have a Main out at U-Mix 1/2 and Cue signal at 3/4.
In the current audio mode you only have a Main knob fader at the right top.
If you want to use the U-Mix only you'd better disable the build in soundcard in the asio4all settings as it takes cpu performance by this causes a higher latency.

[TuomasH]

When i switch the dual stereo sound goes still on one channel or both in soundcard... I dont understand what to do...
https://www.flickr.com/cameraroll <-Theres picture where you can see Asio setup too. But if you know what to do, can you please tell step by step

[TuomasH]

FINALLY, its working now D I just switched the routing mode to: External Mixer and now it works
So now "output 1" is going to "A" and "output 2" in "B"
But thanks to you for big help