help with mapping american audio mxr10 encoder for the libra

[FigDJ]

Could you post your map or at least the code with the modifier?

Edit

Also try this. Locate the command in your code and change the value to read as follows:


<parameter object="map" key="backwardIntegerRange" value="-1 -64"/>
<parameter object="map" key="forwardIntegerRange" value="1 63"/>

[katmoda]

Hi RoJeC

I sent yesterday my bill to the email address specified in your link from the App store to prove my purchase of Cross DJ

Waiting on response now

Thanks again!

[katmoda]

Hi FigDJ

I tried your amendment but it still did not work.
I even tried this on another Mac with the same outcome.

I attach my mapping but I removed out the LED outputs in case there was a clash but it didn't make a difference.

Thanks again for your assistance

MXR10.mappings

MXR10.mappings

[FigDJ]

Hi, I found kind of the same problem with another controller's map.
I found out that the encoder itself is set-up as an absolute encoder.
In order for my commands to work it must be a relative encoder.

Please check if there is a way to change the encoder type from your hardware set up or try using the Cross MIDI learn to map as an absolute encoder. (it may work but have to make the steps really small).

In the mean time i will look for a solution too and will let you know.

[katmoda]

Hi FigDJ

Thanks again for your assistance i really appreciate!

I will try using the Cross MIDI learn again

best wishes

[katmoda]

Hi FigDJ

I did try to map again but it did not work. same result as before

Thanks