[resolved] Dual Stero Not Working Correctly?

[ddjj]

Good Morning!

I'm not sure what' is going on!

My dual stereo is not working as it is in 2.6.

When I move slider to A, I can still hear the song of B (if its playing).. but if the slider is all the way to B, song A is gone (as it should be)...Again, I went back to 2.6, and compare, and is working as expected....

I uninstalled/reinstalled 3.0....what did I screw up?

Thx!
DDJJ

[djmagicmoments]

Are you using a controller? Which one?

Dual stereo only worked for me when my controller was attached.

[RoJeC]

Post a screen capture of your v3 buttons/faders. Likely easiest to show what settings you have. Select your total screen.
(Save to file and upload as attachment to your reply)

[ddjj]

I use Quneo controller but I have it disconnected, and Im using the mouse with the same symptoms....as for sending a screen shot of the buttons and feeders, do you mean the player GUI or the audio section in the Cross preferences?

Like I said before, 2.6 is working fine!

DDJJ

[ddjj]

I was messing around with buttons:

Went to video effects and changed "pixelate" to the next one down and then back....

Problem gone! Freaky! I'll keep and eye on it!

DDJJ

[RoJeC]

if you used MIDI the fader might not have connected with gui position of fader.
if you post the total gui that should be a start given your description. if you post pref audio then likely all info is there.

[ddjj]

as stated....problem was with n without controller...with internal n external soundcard....it cleared when i states as above...i will keep an eye on it.
thx
ddjj