Kontrol Z1 F1 and now X1 MK2

[gullum]

I'll play with one button till I get it right

[Hannes]

if you want to map the pad's color according to the pad mode it's as easy as assigning them sepereatyl for each sent message.

e.g.:
<mapping>
<control alias="fam(Sampler)[0x1].Pad2Mode" value="0">
<MIDI type="Note" parameter="0x5" channel="0x1" value="127"/>
</mapping>

basically you`ll need to do this for every color/mode and always manage the other cases too.

so if for value "0" you want a clean red-led output, you'll need to set the output for the red led to "127" and all other led outs to "0".

So with RGB lighting it should work like this, of course with the right midi-values

<mapping>
<control alias="fam(Sampler)[0x1].Pad2Mode" value="0">
<MIDI type="Note" parameter="0x5" channel="0x1" value="127"/>
</mapping>
<mapping>
<control alias="fam(Sampler)[0x1].Pad2Mode" value="0">
<MIDI type="Note" parameter="0x6" channel="0x1" value="0"/>
</mapping>
<mapping>
<control alias="fam(Sampler)[0x1].Pad2Mode" value="0">
<MIDI type="Note" parameter="0x7" channel="0x1" value="0"/>
</mapping>

[P_Jean]

<mapping>
<control alias="fam(Sampler)[0x1].Pad2Mode" value="0">
<MIDI type="Note" parameter="0x5" channel="0x1" value="127"/>
<MIDI type="Note" parameter="0x6" channel="0x1" value="0"/>
<MIDI type="Note" parameter="0x7" channel="0x1" value="0"/>
</mapping>


is better ...

[Hannes]

no, is only shorter hahaha
cheers PJ

[P_Jean]

no, is only shorter hahaha
cheers PJ

Arf, no, my friend ! Better ...
Mine is : Cross read 1 condition with 3 actions ...
Yours is : Cross read 3 similar conditions with 1 action.

Even though the result is the same, it is creamy one only requirement.

Cheers too !

[Hannes]

ok, agreed.

but for me it didnt work properly....
Edit: that was a different map I thought of, this works

[P_Jean]

Because you need to change the value of the PadMode.
Change the action for the different values, if you want a good result.

[gullum]

ok now I tried all 3 of them with Propellerhead Reason to figure out what chanels and notes each button sends in/out X1 MK2 sends all on channel 1 and sends in/out the same note but no matter how I try I can get LEDs working with Cross. The Z1 gets the VU LED from CC3 and CC4 on Channel 3 but not working with Cross

[djhatch]

any luck getting your F1 mapped? if so.. can u share the map file?

[Sonido Los Reyes]

any map for the control x1 mkII and the kontrol z1?