U-Mix Control 2 to Laptop and To Home Theather

[johnnyhood]

Hi,

My setup:
U-Mix Control 2 to Laptop and To Home Theather 5.1 with split like this http://www.mixvibes.com/content/products/dj-cable but the split sound it not working in the CUE from source A or source B headphone.


Please advice.

[daniel clark]

what sound card are you useing and what is your audio config look like ,,, the home theater 5.1 is your amplifier ,,correct
next is what are you trying to accomplish

i think that to use the cable in link the audio config must be in split mono

[johnnyhood]

Hi Daniel,

Nope. from Laptop 3.5mm split jack into two direct to home theater and the other is headphone.

I tried SHIFT + Source B or Source A but not coming (working)

My_Setup.jpg

[johnnyhood]

the home theater 5.1 is your amplifier ,,correct?

YES Daniel.

[daniel clark]

if you look at the routing that the split mono set up ,, the right channel is for the headphone side of the plug ,,,the left side is for master ,,, for the software to control prefade listening (monitoring ,,) it has to see two set of seperate inputs ,, not possible with a single sc .. what you will be hearing is a mono signal from one sc


Got to have a multi channel sc or use asio4all to add two sc together to have one pair of chanel to master out to your amp and the second to use for monitoring sc is sound card ,

[Blackbrook]

Daniel, that should be the "slpit mono"'s advantage: no need for a multichannel audio interface.

@thread starter: choose Output1/2 for both, Master and Cue. I am not sure, but I think this might solve your problem.

Let us know if it works or not.

[johnnyhood]

Daniel/Blackbrook,

Yes I did what you said but when i use right channel for the headphone i heard also in the home theather even i split into mono in the left side for master.

I used also USB sound card additional of the existing build in in the Laptopn but the problem the software "Cross DJ LE 2.3" routing sound "not split mono" did not change the "Output 1" or "Output 2". When i choose output 1 automatically the output 2 is changed into none.

When i VIRTUAL DJ software. it's working but not controlling with U-Mix Control 2 hardware.

Please, try it with your home theather.

Thanks guys,

[daniel clark]

:idea:


Got to have a multi channel sc or use asio4all to add two sc together to have one pair of chanel to master out to your amp and the second to use for monitoring sc is sound card ,

have you tried asio4all when trying to use a additional sc (usb ) ,,also use dual stero when you get the usb sc reconized by the software

[Support@MixVibes]

if you want to use the laptop outout, you need to use the 'Split mono' setting.
The as said master will go on the left and headphones on the right.

So your speakers need to be hooked to the left.

Also check your cue/cue mix/master knobs into the software.

[johnnyhood]

Daniel,

See my setup

Got to have a multi channel sc or use asio4all to add two sc together to have one pair of chanel to master out to your amp

i did but it can't work.

Fig A

setup _Umix.jpg

setup.jpg