MIXVIBES Dj Community old forum

Is it possible to make several different mappings for the same controller, and have a key on the controller used to switch between the different mappings?

And if we're already on the subject, what does the "shift logic" function do? Didn't find anything on it on the manual.

Ok, understood the shift logic function. Still searching for an option to use a button on controller as a loader of different mapping.

Also, I know my controller (Behringer CMD-DC1) has an option of switching the color of the lights. Can I control this option from Cross?

Idan Korenblum wrote:Ok, understood the shift logic function. Still searching for an option to use a button on controller as a loader of different mapping.

In mapping my Quneos an d the 4 deck map for the UMCP-2, I used to have several map pings. Later on I combined them into a single mapping with a switch using shift logic.

Example on the UMCP-2

All Player commands for players 1 and 2 use normal commands.
All player command ( while using the same MIDI parameter/ button) player 3 uses ML1 and player 4 uses ML2. Then set toggle button to activate shift logic.
When I activate ML1 I am controlling player 2 and when I activate Ml2 I am controlling player 4. All in one map

Hi Idan,

If the problem still exists!

The status LEDs for the CMD controllers I take with the program by Daniel Linde Felser (CrossMap). This is an additional small program using which you can edit the mapping file very easily and with the GUI. look under the following link after (http://danlin.de/projekte/crossmap/) and contact Daniel.
I am very happy with this tool and have no problem to map the Behringer CMD series properly. (LED ring, color change, etc.)
Greetings from Norway

Thanks a lot. Do you have any manual for how to use this software?

radioVIKI I sent you a message about this. Maybe we can get in touch and chat about it, it will really help me! Thanks.