MIXVIBES Dj Community old forum

Good Morning!

I'm not sure what' is going on!

My dual stereo is not working as it is in 2.6.

When I move slider to A, I can still hear the song of B (if its playing).. but if the slider is all the way to B, song A is gone (as it should be)...Again, I went back to 2.6, and compare, and is working as expected....

I uninstalled/reinstalled 3.0....what did I screw up?

Thx!
DDJJ

Are you using a controller? Which one?

Dual stereo only worked for me when my controller was attached.

Post a screen capture of your v3 buttons/faders. Likely easiest to show what settings you have. Select your total screen.
(Save to file and upload as attachment to your reply)

I use Quneo controller but I have it disconnected, and Im using the mouse with the same symptoms....as for sending a screen shot of the buttons and feeders, do you mean the player GUI or the audio section in the Cross preferences?

Like I said before, 2.6 is working fine!

DDJJ

I was messing around with buttons:

Went to video effects and changed "pixelate" to the next one down and then back....

Problem gone! Freaky! I'll keep and eye on it!

DDJJ

if you used MIDI the fader might not have connected with gui position of fader.
if you post the total gui that should be a start given your description. if you post pref audio then likely all info is there.

as stated....problem was with n without controller...with internal n external soundcard....it cleared when i states as above...i will keep an eye on it.
thx
ddjj