MIXVIBES Dj Community old forum

in the first moments of the soft-fader does not work, start to work after a few movements. But on the screen, the program shows that rotates faders

a little bit better explaination,,more info ,, ,, useing MIDI controller ,, control of gui ,, explain

Numark Mixtrack, Cross DJ 2.5

when slider doubles, not wroked.

When you move the slider faders doubles. Then a few times to move and becomes normal.

At version 1.5, this was not. The slider was moving normally and once worked.

This is the "soft take-over" feature. You must reach the software value before the hardware position to be taken into account.
It avoids jumps on continuous controls (knobs and sliders) if you start playing before moving all the controls.

sylMV it is not working properly.
I turn the fader, and he doubles.
I turn the fader on controller and on the screen also rotates, but doubles. Moving without the red stripes.
Crossfader also

Just for info ,open up MIDI preferences and turn software take over off to see how it reacts (labeled take over batch ,,all/none ),, also what is the version # of the midii mapp you are using ,, may be a screen shot will help ,, also what are you meaning by doubles

daniel clark picture above
+ more picture

1- not normally
2- normal, after a few times to move

daniel clark These buttons are not active.

The problem is not in the controller. It works good in old versions Cross 1.5 and other dj-software

DjTom wrote:sylMV it is not working properly.
I turn the fader, and he doubles.
I turn the fader on controller and on the screen also rotates, but doubles. Moving without the red stripes.
Crossfader also

You didn't get what's "soft take-over". The second value (the ghost one) is shown so that you know how your controller and the software are out of sync. Make the ghost reach the normal value and then your knob is back to business, as Cross ensure it won't jump when turning it.

DjTom wrote:daniel clark These buttons are not active.

The problem is not in the controller. It works good in old versions Cross 1.5 and other DJ-software

As Daniel told you, you can disable "take-over" on user mappings.
Here you are trying to modify a built-in (read-only) mapping.
Duplicate it using the [x2] button and then you'll be able to make any changes you want, take-over included.