MIXVIBES Dj Community old forum

would like to lock in sampler pads mode for each pad/sample ,,have tried changing them ,,but every time i close and re open Cross and load sample banks they are reverted to loop , some thing i am missing ,, info on this please

They should stay saved if you save a sample-bank and reload that.

but for new samples they´re always set to loop.

have saved sample banks and edit mode in the info tab ,,still coming on as loop ,,,maybe not saving them right ,, missing something

hm, i thought this was fixed, obviously it´s not :P
probably in the next release.

kool,,verfiy the next time just to double check before crying wolf

this has been a concern since 2.0 ,,,think its same in 2.2 ,,know its same in 2,1 played hard with it last night and this morn ,still not saved at least in that version,, ,,may be it has been changed in 2.2

Into the 2.3rc, I did this :
- hotsampling the first 3 pads with a different settings for each of them (full/1-shot/hold
- saved the bank
- quit Cross
- restart
- reload the saved bank
All my pads still have the assigned mode.

Then I go into 2.2
- load the saved bank
and all my pads still have the assigned mode.

I re-did the whole procedure by creating a new bank with 2.2 and re- open it into 2.2 and it sill works !!!

So for me saving/re-loading pads mode is ok.
Any special scenario to trigg the issue ?

no but will try again with 2.2 ,,

Did you load a sample bank, or just sample tracks associated within the bank? Make sure all the samples you want in a specific playmode have indeed this playmode in your bank

There is an issue when using the submenu (and command) for a track : "load into sampler -> Pad "
But loading a sample bank should set the correct play mode