turntable 1 not callibrating

[ac1]

i have just tried using mixvibes again after not using it for a while from previous problems, when i try to calibrate only turntable 2 does it succesfully, but usually says that it has detected left and right reverse and phase invasion but will be corrected, what does this mean?

but with the turntable 1 it wont work it says check the needles and vinyl, i have done that and nothing changes, i am using ttx's and was wondering if it could be a fault on the decks?

i have still tried to have a mix and can do it one way, but deck 1 always either does not work at all, or will work and play backwards. some advice a while ago told me to download asio4all, i have done this and configured it but have still had the same problem.

i have tryed attatching a file with the screen shot of the vinyl/cd iput are of options, but the file was too big apparantly and it wont let me paste it in, thought it might help. i am new to this and dont really know what all the options are but can anyone help. i have looked all over the forum and cant see anything like this. much appreciated.

[phadedvision]

Hi ac,

The phase inversion has to do with your needles, but it doesn't actually effect anything. It's just how the software works.

For your issue at hand, is deck 1 grounded properly? Is it possible for you to post a config report?

[Support@MixVibes]

If it play backward it's because left/right channel are inverted.

Swap both deck to see if the problem change side too. If it does then you have a faulty deck.

[ac1]

there is no need for a grounf on ttx, i neever had one in the 1st place.
but i have swappede the dex round and when i did it was turntable 2 that was not working which was the same one as in the 1st place, i think it may be a faulty deck because it was always that one that i was having problems with. but then i changed the dex back round to how they used to b and i cant get either of them to calibrate now, i have played with the needles and the vinyl and nothing helps, once or twice it worked but then when i tried to re calibrate the other one it would say that both decks arent calibrated i dont get it.

if i do have a faulty deck how would i go about to fix it or to get it looked at?

[hemskoc]

Hi.
Swap everything you can to try and find a fix before you even consider sending them for repairs dude (Needles, Cables, Decks)
if have a friend that has a deck you can borrow to see if its the soundcard. ..even maybe try a normal vinyl record aswell to see if the basic functions are working.
TRY EVERYTHING YOU CAN...Dont give up mate .
Strange that its not working AT ALL now ??? Seems there is something weird going on if it worked b4- keep trying

As for getting them looked at, contact the manufacturer.

[Support@MixVibes]

Pins connectors near the head-shield often give headaches.

[hemskoc]

Pins connectors near the head-shield often give headaches.

Very true! jiggle around your needle/stylus heads to make sure they have proper contact also!
Cheers

[ac1]

i have been playing around with everything that i can think off for now and nothing seems to be working. i am going to take my laptop to a mates and see if it works on his decks, if it does then it should be mine with the problem right? if not then back to square one. i think it must be the decks but only when i use mixvibes becuase when i use my vinyl evrything works how it should. right from the start when i got mixvibes a year ago i had the same problem with the one deck. will post when i have tried on other turntables.

[Support@MixVibes]

Sometimes on true vinyls you won't notice that there is a phase inversion, or that the sound is in double mono or that left/right are inverted.
But with a DVS you immediately know.