Mixvibes DVS both inputs to one output

[Malkuso]

I have 2 problems with my newly installed Mixvibes DVS with MK2. First, I can't calibrate the vinyl records to mixvibes, second I can press play on both player 1 and 2 in the program but both players output comes through output 1.

DO anyone know how to solve this?

Best regards Markus

[Blackbrook]

On the right hand side of your bypass button there is a field with a '1' inside. At the other deck there is the same field. If there is a '1' in you have to change this to '2' so the decks send their sound through different audio interface channels if this audio interface is installed correctly.

[FJCharlie]

hi, i'm new to this but i'm alot into computers... but this this is a nightmare.. this 1 or 2 button, doesn't work. i press it nothing happens it stays 1. both deks play into left chanell i just can't assign right deck to right chanell. every time i want to play i have to reinstall mixvibes and calibrate everything over and over again. + after first "next" button i get "u46 asio driver not present"
can anyone please help? i just don't get it...
thanks in advance
FJC

[gakto2009]

Run the config wizard n select your options according to your setup... this will do all the leg work for you.

regards,
Bryan

[FJCharlie]

thanks for fast reply, but it may sound a bit stupid.. where is that config wiz? in mixvibes i have only install wiz.
i folowed everything you said in installing driver + sowtware, adjusting card and so on.
i have vista x64 so i used asio all driver

ah edit*
i just noticed everythings fine untill i put a song into deck 2 than it switches to chanell no.1

[gakto2009]

show us a screen shot of your asio4all config panel please.x

[FJCharlie]

original pic http://yfrog.com/0xherefgj
this "mixer" or something has no moveable sliders as the black one

[FJCharlie]

ok so i found selecting chanell options, damn what a bummer..
but i still dont get it why do i get no asio driver note
setting chanell options is at: options>soundcard>set number of outputs to 2 (mine was default 1)> then setup> assign to first chanell U46DJ 1 for left and U46DJ 2 for right, then under is a left (second chanell, set to U46DJ 3 for left and U46DJ 4 for right... now you can press the 1 or 2 chanell button\window...

but this note i dont get... + i would like to ask you how did you set 128 or 256 samples? i get lowest 480 or mid 512
tnx in advance for your help
FJC