Technic 1200's will not work with Cross Pack

[kooldjgrego]

Can anyone please give me guidance. I have tried several times and I can not get my Technic 1200's to work with my newly purchased Cross Pack.

[phadedvision]

Hi DJGrego, do you have everything set up and plugged in properly?

[kooldjgrego]

I have the classic Technic 1200's with Behringer djx700. Their the only equipment I can use at the time. I have a pair of Denon S5000 but no MIDI support (Cross Pack) for them at this time.

[phadedvision]

Pretty good setup you have there. However, do you have your soundcard plugged into your laptop and mixer? Also, is your software set up accordingly?

[kooldjgrego]

table 1 is pluged into 1/2 in
table 2 is plugged into 3/4 in

1/2 out into channel 2 line
3/4 out into channel 3 line

soundcard is set to phono both sides

everything else is set as prescribed in manual

[jiel]

you have to choose your U46MK2 in the Sound configuration panel, and active the 4 input and 4 output.

Then, go in the Vinyl preferences and activate the vinyl control.

Your technics work with Cross, you just have to set your soundcard and vinyl properly.

[kooldjgrego]

Do I use ASIO or not. I am still having problems with my Technics. I noticed my MIDI is on CD400. Will that cause a malfunction.

[TAURUS]

Yes, you have to use Asio, that's important.
and if not try to re-install the drivers of your soundcard.

good luck
Pat

[UncleVibes]

I noticed my MIDI is on CD400. Will that cause a malfunction.

Asio & MIDI aren't related.