by gakto2009 on 27 May 2009, 20:44
you need three different controls...
to select view use,
0 = current view 1 = media base 2 = explorer 3 = playlist.
so to set it up to use each window from MIDI you would need to use 3 different sets of MIDI controls.
set one for media base, up/down load,
set two for explorer, up/down load,
set three for playlist, up/down load,
it is possible to have a communal load button using "0" for current view.
it is also possible to use a MIDI button to nav to your view, then set the up/down controls to "0" (current View). this would allow you to use one MIDI control for the active view.
regards,
Bryan
..!.. ..!.. NO SUPPORT BY PM ..!.. ..!..