HELP! can´t config audio out+monitor mixvibes PRO 7.21

[angel valtierra]

Hey, guys. I´m a little worried, I have my first gigset at a club on Mexico city on May but I am still havig serious config. issues.
the most important thing, and I can´t get Mixvibes to do it right:

CUE !!!!

no matter how I rout my output channels, I just can´t seem to be able to do it right. I really need a hand on this, please.

I already read the tutorial. So I have the feeling that weather there's something wrong or I am really stupid, maybe both, but none of them is a cool feeling. Anyways, this is what happens:

whenever I try the 2 outputs only, and choose the first pair -1and2- for output, and the second pair-3and4- for monitor, all seems fine:I can cue both decks, but I get no output signal from one side.

whenever I choose the 3ch. opt.
1and2 for L
3and4 for R
5and6 for Monitor,
the channel I´m cueing comes out to my monitor -good- but then, it goes trough the master output too- sucks-, 'cause then i get an unwanted pre beat matched mix out and have serious volume falls and blows as i press cue button.

There´s a 3rd Opt. I read about, which consists on routing both decks to come out through the same ch., but Mixvibes just doesn´t let me do it, not 7, 7.1 or 7.2.1. When I click on "setup" i get the ch. config opt. I click on the down arrows on 2nd line, but, ch. 1and2 just aren´t there again, they`re already chosen on the 1st line, so I can´t pick those again. Any tips?

As you see below I´m using no audio mixer, just mi BCD-3000 as MIDI mixer, the U46MK2, 2TT an running XP on my macbook.

Any Help would be really appreciated. thanx a lot for takin' the time for reading and posting.

Sending goodvibes to all he MV community.
VDJ PHUNX

[TuXxL]

Hello,

We will try this first.
Configure your U46 MKII to have channel 1/2 and channel 3/4 for outputs.
Then click on monitor for the 3/4.

Then see your decks and look for decks' number. Put the same number on both decks (put 1/1 instead of 1/2 or put 2/2 instead of 1/2).

Then it should work...

[angel valtierra]

Allright!

thanx a lot 4 the quick response TuXxL,

I'll try your tip and reply with results.

In the meanwhile:

good karma 4U!!!!

PHUNX

[angel valtierra]

IT WORKS!

this is what i did:

go to
options/soundcard/
select 3out. configure 1and 2 out
mark 3and4 monitor
5and 6 out

---Then see your decks and look for decks' number. Put the same number on both decks (put 1/1 instead of 1/2 or put 2/2 instead of 1/2).---- I put them both in 1.

This is kind of funny, though, cause I have routed 5-6 wich are not even connected on my soundcard. But anyways: It works!!!!.

thanks a lot, TuXxL. so is that ok? I tried 1st w/ just 2 outputs, but I'm not sure it work'd. you think I gotta get rid of the 5and6 ch. and use only 2 outputs or is it coo
l as it is now?

Again, I'm really thankfull.

PHUNX