How to callibrate the turntables.

[Marlon]

Hi
I work with MIxvibes and a Esi u 46 SE.
And i am not able to callibrate my turntables. There is always a message that there is no timecode signal. What exactly do i have to choose in the install-assistent ? i cant get along i am tryin for 8 hours now and i am relly frustrated now...
greetz Marlon

[jiel]

did you plug your u46/turntables/mixer right ?

try to look at this tutorial video for the configuration:
http://www.mixvibes.com/site/pageeng/page.php?x=video

(New DVS PACK MK2 - Installation tutorial)

[Marlon]

Yes... and when i take the PC of my brother in my room and i do EXACTLY the same steps, then it works, than i do the same on my PC again and all happens the same, but the players cant be callibratet.. how can this be ?

[phadedvision]

Could you please tell us more about your computer and setup? Thanks!

[Marlon]

Prozessor:
AMD Athlon 64 Processor 3500+
Grafik:
Nvidia Geforce 6600 GT
ARbeitsspeicher (sorrry dont know how to say this in english):
1023 Mb
used: 35%
Motherboard Chipsatz:
nVIDIA nForce4, AMD Hammer

is anything missing ?

[jiel]

if your setup works on your brother's PC, then your hardware is good, and you do the right configuration of MixVibes.

Its probably a problem with your PC. Whith OS are you using ?
XP, VISTA ? do you have the last Service Pack ?

[Marlon]

i use xp and got the llast service pac.. I found out now that mixvibes works if i disconnect all the other things connected with usb...
First of all i am really happy that i made mixvibes run=) but some of the things i had to disconnect, i really need also while mixing..
greetz MArlon

[polocorp]

you probably have a USB energy issue. you should get a power supply for your U46 to take some strain of your USB ports. You cen pick one up at a hardware store.