hi everyone

[youngy]

hi there one im all new to the DVS world

one thing how do i sort out the sound on the Ultimate kit sounds
far to bassy

im using window 7 Ultimate and didnt understand the instructions propley any advise would be ace

[daniel clark]

welcome to mixvibes fourm,no need to explain to you the magic of regerstering ,,you got it ,,moving the topic to DVS fourm pages where you will find info as to problems and solutions , not familiar with DVS to help you ,but some one there will assist you

[youngy]

thanks dude hope to get solved then and can get mixing and cutting once again

[daniel clark]

the more info the better ,what are you refering too explain ,too bassy ,,info as to your set up ,more info because its too general what you are ashing could be a lot of variables ,,need more info

[youngy]

MY SET UP IS 2 TECHNICS 1210 Vestax PCM06 PROD MIXVIBE Ultimate AND PC RUNING 7 Ultimate WEN I PLAY A TUNE THERE AS HELL OFF A LOT OF BASS MY EQ IS SET TO MIDDLE AS NORMAL WAT IM ASKING IS THERE ANY THINK IN THE SETTING I CAN CHANGE AS IM USED TO USEING VINYL ALL THE TIME SOFTWARE AINT MY STRONG POINT IF THERES ANY OVER INFO YOU NEED LET ME KNOW

[Blackbrook]

Do you think capital letters change anything?

[youngy]

haha forgot to take it of anyway i need help geting the sound right as the bass takes over everythink ive tryed all differnt setting adjusting my volume in windows but no look some help please wen i play i track it seems to be more bass than anythink also music comes though but the input lights dont flash i really wanna get into this DVS lark but the bad sound is puting me off if anyone can help would be ace

[wazza]

Ok ..have you try'ed to turn the mid's and low's down in the software...the old 06 pro has a 2 band EQ ( HI LOW )., mixvibes DVS has a 3 band EQ ( hi , mid and low )...so the mids and lows in the software might be coming in to hot for the mixer

[youngy]

yh tryed that and ive got the sound ok now but had to turn my hi end up to max just sounds so drome and dont think it meant to be like that

[wazza]

ok that dont sound good...

lets just see if you have set it up right ...from your 1200,s rca outputs (left turntable out-puts 1 and 2 + right turntable outputs 3 and 4 ) .., into the input (1,2,3 and 4) on the U-Mix 44 ( swich to phono pre-app{ not line}..
the outputs on the U-Mix 44 go to the line inputs on your 06 pro mixer (not the phono inputs ).., swich mixer to line on both mixers channels ...for ground cables from your turntables ...you can ground to your mixer but its better to ground to the sound card if you can...

can you do a CONFIG REPORT ...with both the turntables running ,with the turntables pitch set on both to 0% and post here
so I can see how you have the DVS software setup