MixVibes Headphones Project

[BennyB]

Hey guys.

About a week ago, My headphone got beaten up, I wasn't careful enought and I accdentaly pulled it out of my mixer folowd by a big drop on the ground.

Result: The wires in the jack plug came of from it joints, and the right earpiece broke of from the nuckle.

So I started thinking about what can I do, and I rebuilt it.

Well, it's not finised, only a soldering work is remaining, but I'll post the final result.

Untill then, check the pictures

[KevMaverick]

Not a bad repair - you wouldn't know they had been broken.

[BennyB]

If you watch closer, you'll be able to see cosmetic "bugs", but they are barely noticable, and the picture is too bad, to spot them.

I only left my solder in college, so I have to travel a bit, to make them finally together.

[BennyB]

The headphones are completed

They are very nice

[rhopkins]

That's really quite impressive!

[BennyB]

That's really quite impressive!

It should be... I had to saw apart the original headphones, to be able to this one

Luckyly I didn't messed up the sides, so the sides are exactly the same as the original.

The only thing I will do later is to add a Neutric 3,5mm Jack plug onto the end