MIXVIBES Dj Community old forum

you need to mute the monitor of your inputs in the control pannel of your sound card to stop the beep sound.

Support@MixVibes wrote:
Wiring :
- both usb deck on the computer with a usb cable and a timecode cd (no audio cable !)
- usb audio dongle on the computer with the headphones (monitor)
- the main ouptut hooked to the computer on the integrated/Standard soundcard (sound going to the speakers)

Configuration :
- launch MV
- go to preferences/options/soundcard
- sélect asio4all and 2 outputs
- go to asio4all

iscratch_01.JPG

in my case :
* Conexant is the internal soundcard and I've only selected the needed output for the main.
* USB audio codec is the iscratch, I only choose the needed input
(do the same for each deck)
* usb sound device is the usb audio dongle

then go back to MV :
route the outputs like this

iscratch_02.JPG

So I have one output for the main and the other for the monitor You can also do the opposite by putting the monitor dot on the correct line.

Now I will setup the inputs :

iscratch_03.JPG

Do the same with your both deck (I only have one)
As said from the begining you have to keep the less things into asio4all.
Don't forget to activate VINYL on the gui to have the control !

unnamedmixer wrote:so, to connect cdj to PC do i need an external soundcard?

Jim B wrote:

unnamedmixer wrote:so, to connect cdj to PC do i need an external soundcard?

Yes, a 4input/4output card.

Inputs from your CDJ's connect to the inputs on the card, the 4 outputs of the card connect to 2 channels of your mixer.