MIXVIBES Dj Community old forum

Can anyone please give me guidance. I have tried several times and I can not get my Technic 1200's to work with my newly purchased Cross Pack.

Hi DJGrego, do you have everything set up and plugged in properly?

I have the classic Technic 1200's with Behringer djx700. Their the only equipment I can use at the time. I have a pair of Denon S5000 but no MIDI support (Cross Pack) for them at this time.

Pretty good setup you have there. However, do you have your soundcard plugged into your laptop and mixer? Also, is your software set up accordingly?

table 1 is pluged into 1/2 in
table 2 is plugged into 3/4 in

1/2 out into channel 2 line
3/4 out into channel 3 line

soundcard is set to phono both sides

everything else is set as prescribed in manual

you have to choose your U46MK2 in the Sound configuration panel, and active the 4 input and 4 output.

Then, go in the Vinyl preferences and activate the vinyl control.

Your technics work with Cross, you just have to set your soundcard and vinyl properly.

Do I use ASIO or not. I am still having problems with my Technics. I noticed my MIDI is on CD400. Will that cause a malfunction.

Yes, you have to use Asio, that's important.
and if not try to re-install the drivers of your soundcard.

good luck
Pat

I noticed my MIDI is on CD400. Will that cause a malfunction.

Asio & MIDI aren't related.