djsamrties wrote:here is another few little notice...
in the excel file, in mixer sheet, i think that you have forgoten the line about HEADPHONE MIX.
I did not forget. I left that out on purpose because it is a harware button. The settings for that are describe on page 1 of the DDJ-SX pdf file provided by Mixvibes. This file describes the set up and proper position for the GUI and controller buttons which I am pretty sure I mentioned as a caveat for the mapping couple of times.
djsamrties wrote:With the button to switch between ch 1/2 or MASTER level, it only work with 1/2 channel. And i think that in an ald version of your map, it was possible to switch and see MASTER level with it.
I just looked again at the MIDI tables for the controller to verify. Please make sure you are set up correctly. On the DDJ family of controllers Channels 1,2,3,4 control the level meter and they are mapped accordingly. The master level meter is hardware controlled.
djsamrties wrote:in the excel file, in mixer sheet, i think that you have forgoten to write FADER CHANNEL just above CUE. and the description for use FADER CHANNEL + SHIFT isnt the good description.
I didn't think it was necesary to explain the channel fader. For a matter of completness yes it should be there.
Just to make it clear to anyone watching the tread. The xcel file that djsamrties is referring to is just a descriptive file that does not affect the operation of the controller.
djsamrties wrote:i think that the SHIFT + SLIP doesnt work. it normaly have to load and read the same track that the master isnt it ? if its that, it doesnt work for me.
Make sure that you are not usinf version 3.0 of Cross
In 2.6 it worked.
in 3.0 It was broken
In 3.1 it is fixed.
This was one of the bugs that i called out during testing.