ddjj wrote:Hmmm:
Not sure I follow...the example you show seems to light up a single drum pad....I have four locators on a single pad in grid mode....so wouldn't I use channel 2 for each corner....?
I want to light-unlight each corner accordingly.
Thanks
DDJJ
the example is a general example for the commands. For individual lights within a pads you must use the Quneo editor to place the pads in remote LED mode. Also take a look at the advanced LED tab in the editor for the pads and it will show you the channel for the preset that you are using.
Grid mode individual LEDs are normally set for channel 2. Within the Quneo manual there is a layout for grid mode that tells you the individual MIDI note to use for each LED. You must convert that value to hexadecimal to map it in Cross. There was an XLs file that I posted with the conversions already done. Do you have that file?