ddjj wrote:Thanks everyone!
I am still looking for the "command" to make this happen...I have looked thru all the commands, and do not see one that seems to fit......i.e Cross Fader Flash or the like!
and also what would be the "command" to light up a single pad that I have for SYNC....?
DDJJ
Crossfader command
In&Out fam(Mixer).Crossfader (Normal)
Input mapping for crossfader
- Code: Select all
<mapping>
<events>
<MIDI type="CC" parameter="0xa" channel="0x1"/>
</events>
<controls>
<control alias="fam(Mixer).Crossfader"/>
</controls>
<preset name="Direct Fader/Knob">
<parameters>
<parameter object="action-0" key="action" value="SetNormalTakeOver"/>
<parameter object="dispatch" key="centerCCandPWvalueRange" value="64 64"/>
<parameter object="dispatch" key="useCenteredCCandPW" value="off"/>
<parameter object="invert" key="on" value="off"/>
</parameters>
</preset>
</mapping>
Output mapping for crossfader
- Code: Select all
<mapping>
<control alias="fam(Mixer).Crossfader" value="%"/>
<MIDI type="CC" parameter="0x5" channel="0x1" value="%"/>
</mapping>
Sync Command
In&Out fam(Player)[0x1].SyncWithMaster (Logic)
input mapping
- Code: Select all
<mapping>
<events>
<MIDI type="Note" parameter="0x40" channel="0x1"/>
</events>
<controls>
<control alias="fam(Player)[0x1].SyncWithMaster"/>
</controls>
<preset name="Toggler Button">
<parameters>
<parameter object="invert" key="on" value="off"/>
</parameters>
</preset>
</mapping>
sync output mapping
- Code: Select all
<mapping>
<control alias="fam(Player)[0x1].SyncWithMaster" value="true"/>
<MIDI type="Note" parameter="0x18" channel="0x1" value="127"/>
</mapping>
<mapping>
<control alias="fam(Player)[0x1].SyncWithMaster" value="false"/>
<MIDI type="Note" parameter="0x18" channel="0x1" value="0"/>
</mapping>
This is all assuming that you are using Quneo preset 1 and your pads and crossfader is in remote LED mode.
This sync output mapping will light up the top left corner pad in green. Use parameter 0X19 for red.
This is just the example you would have to change parameter numbers for the actual pad you want.
Fell free to PM me for more details