MIXVIBES Dj Community old forum

Hi,

I'm trying to have the ability to reach a cue point AND have a loop at the same time.

In other words, I want to have autoloop engage at specif cue points. The kind of ability found in other software where you can have several loops defined in a tune.

So I did map several command to the same button on my controller : cue point control + autoloop select and trigger

But it doesn't work. Sometime the autoloop is not engaged and when it is, most of the time, the autoloop is set anywhere further than the cue point.

What's wrong, please ?

Hi Will,

To save a loop on a cue point/locator simply engage the loop before setting the cue. Then it should display the loop start and end time on the cue button.

This will work better than mapping both commands to one button, because as you have found, the MIDI commands are not executed simultaneously.

Let me know if you run into issues getting this to work, you should only need to have the locator command mapped, since the saved loop is linked to the locator it will automatically turn on with out any extra mapping.

Adam @Mixvibes

Thanks a lot. I'll try this as soon as possible.