MIXVIBES Dj Community old forum

Hello!

I just buy Cross. I had Traktor in the past so I'm using my Traktor Audio 6. The vinyls are traktor vinyls too.

When I calibrate, the circle is okay but there's some kind of problem with the speed. If I ignore the message and click in 'absolute mode' the pitch is +50% (and I'm running at 33.333 rpm).

This problem appears in both turntables so I think that there cannot be the wire.

I was testing with the Traktor Audio 6 Panel changing the sensibility from phono to line but the problem is still there.

Please, I need help. I'm going to a tour in 30 days and I need to improve my VJ skills.

I look forward your response!

I am not sure the Traktor DVS vinyls are identical to the Mixvibes ones, actually I'd be surprised if they were. So, get your hands on a set Mixvibes vinyls and try again.

You need vinyls with the same timecode frequency.

Changing from Phono to Line is not going to help you. This only is about the power of the communication (actually the voltage). You should not mix these up as you have a fair chance of damaging your circuits, or even your phono pre-amp if you send Line to it...

You're right! I thought that it had the same frequency. I just buy a copule of mixvibes vinyls by Amazon. I hope it solve the problem.

Thank you!