MIXVIBES Dj Community old forum

Hello
I am looking firmware to the U-Mix Control Pro 2 and the procedure for setting up.
The problem I encounter is on the controller has ignition sources LEDs A and B flash
Can you help me or send me the firmware
Thank you
Vincent

a little bit more info as to your problem ,,
the firmware is installed in the controller and only if you mistakenly try to install the U-Mix Control Pro firmware has there been any issues/need to re install ,,it will take a little bit and sending pm to support for a link to firmware ,,but since this might not be the issue ,,give more info as to try to solve in the intern ,, viewtopic.php?f=262&t=35826
link for contack people