MIXVIBES Dj Community old forum

Hello,

first sorry for my sad english, i come from Germany and Need help for cofig the pionneer ddj sx also better with Cross DJ as now.

I dont know why, but i cant start the mode Setup as the insctruciton pdf. told me.

The Problem also i have is, that i can only use the hotcue pads, but not the roll, slice and sampler pads an others......

Thx :- )

If you use 3.3.11 you should be able to find some mappings for the SX in the MIDI tab of Preferences.

More general solution when a MIDI device doesn't respond properly (with other settings OK) is to switch USB port. This will reinstall the drivers (as most controller are Class Compliant the drivers come from the controller automatically).

Once it works you normally can change USB ports back if needed.

thx, for answer.

Maybe, my question goes the wrong way. Please look at this:

http://www.mixvibes.com/sites/default/f ... %203.0.pdf

This is yours manual. On the second page you talk about the "mode setup" i cant start it! How can i start the mode setupt? Must i click
"shift&sync" or "shift&deck1" and so on.

thank you

NOt sure as I don't have the controller. however as it is before Cross is started I suppose these are the instructions on how to set certain controls before starting Cross.

You have read starting on page 25 of the Pioneer DDJ-SX user manual. get familiar with that section then follow the instructions on the PDF provided by Mixvibes to set up the controller for Cross. Once you read a little bit in the user manual it will become clear how to do it correctly.