MIXVIBES Dj Community old forum

I recently updated my laptop to Windows 10. ASIO4All is not recognizing my Mixtrack Pro in the audio setup. The master volume is being controlled by the Cue Gain and Cue Mix buttons on the Mixtrack Pro. Song preview(Cue) is not working.

HP Pavillion 17 Notebook
Mixtrack Pro
Cross DJ 3.3.11 64 Bit

See attachment.

Any suggestions?

havent been able to open your attachment ,, hopefully a screen shot of the asio panel and your audio config ,, with out seeing thease i would think the outputs are asigned backwards ,, meaning the master out is going to the cue and visa versa might be wrong ,,but thats where i would double check first

Pretty sure Daniel mentioned the way to solve. Asio4all only does audio. The MIDI is handled totally separate by the OS.

Given all possible MIDI values it would be close to impossible to have the controls working if there would be a mix up of MIDI commands.

I converted the screenshots to PDF's hopefully you can open now. I am using the MIDI Mapping for Mix Track Pro that comes with the software. I did not change any of the configurations.

The thing is it was working fine until I updated my Laptop. I had to re-install both Mixvibes software and ASIO4All after the upgrade.

Have you tried swapping Output 1 (to 3/4) and Output 2 (to 1/2) in Audio settings.

If this makes a difference there likely is something in W10 that handles the order of channels differently. Knowing this will be the first step in digging into it.

When I switched the outputs.

When playing a song on Deck A with the crossfader all the way to the left. I can hear the master volume in my headphones and from the speaker and the cue-preview is still not working. When I start the song on Deck B I can hear both songs in my headphones and from the speaker.

You have the Mix knob fader opened somewhat, so the Main output is also send to your Cue.

Could you maybe also post a screenshot of the overall Cross GUI, without any other opened window.

The current screenshots don't tell which of the decks should be routing to Cue output.

Sorry, can you tell me what is GUI.

Graphical User Interface

So in this case the overall screen of Cross.... Same as the earlier but without the overlay menus/windows.

See attached. Hope this is correct.