MIXVIBES Dj Community old forum

Making a custom mapping for my Reloop TM4 and I had a spare knob (FX1 on the left side) so I decided to map it to the zoom level. This worked quite well for ten or so seconds before CrossDJ crashed and gave the typical Windows "CrossDJ.exe has stopped working" message.

After restarting CrossDJ, everything works perfectly but if you make any considerable adjustment to the zoom level using the MIDI knob, it would yet again crash. You can tweak the knob slightly without the application crashing, but any significant movement would produce the same type of crash.

I am thinking that I am zooming around too fast and it is too much for the program to render or process, which really should be fixed.

I am running CrossDJ v3.3.10 on Windows 8.1 with an Asus S551L. All the Reloop firmware, drivers and ASIOs were checked to be up to date.

Could it be your moves go out of range, so if you turn slow but keep on turning does it also happen.
Is your fader endless or has it fixed begin+end position.

It shouldn't crash Cross, but if the latter you might try to reduce the range for the fader meanwhile (somewhat depending on the available parameters).