MIXVIBES Dj Community old forum

Hi everybody,

I have a short question on the U-Mix 44.

Is there a configuration menu in which I can set the inputs of the sound card to phono inputs?

I found this option in DVS Ultimate, but when I want to use the interface for another software it is not possible.

Thanks for any answer.

Regards
Stefan

In the downloads section you can find a control tool for the card if I'm right. If there would be away it would using this tool I guess.

Don't have the card... so sorry if i'm wrong.

Hi,

it doesn´t work, because there is no switch for line/phono in this tool.

:-(

Any other ideas?

Might be someone has this to work....
Meanwhile what OS are you using. Might be relevant.

I'm using Win7.
The other app is Virtual DJ 7. Might be also very helpful.

st3vnkin9 wrote:I'm using Win7.
The other app is Virtual DJ 7. Might be also very helpful.

have you checked in the vitrul DJ help fourm for resolution of your issues and maybe a solution

I also started a thread in VDJ forum.

But I think that the issues is located in the device driver which is integrated in MixVibes.

Or is there an external driver with advanced options available?

trying to figure out if the switch to shift inputs from line /phono was /is in the software of DVS 7 ,, if so the software you are trying to use should have the same in order to work/get what you want accomplished ,, or was it in a control panel for the sc,, not familiar with the soundcard or its set up for DVS ,, so just tying to get answers

Here is the screenshot of the settings which are used in Ultimate 7.
Player 1 is set to phono=yes (bypass signal OK)
Player 2 is set to phono=no (bypass signal to low)

In VDJ there is no option like this. So the general question is..How can I set this "preamp" option without Ultimate 7 ?

:cool: just curious as to the driver you have installed