by hbehner on 29 Jan 2015, 10:34
I've spent countless hours mapping the xone dx to 4 channels. Your 2 channel map included in the software and 1 other users 4 channel map I could have done in 60 minutes. My problem is with my CABD layout. Channels BD both cue correctly with corresponding channel meters and master vu meters. Channels CA cue correctly but the master vu meters (but not the sound) increase greatly when the headphone cue is selected. I have used the CrossMap MIDI editor to set the MIDI return values. However sometimes the source from the CrossMap editor doesn't match the notes or cc I input. I have tried deleting the controls for Channels C&A channel meters and entering them again but that didn't fix the problem. I am just spinning my wheels now. Any advice would be appreciated.
On a positive note.... I was getting ready to purchase Traktor for at least 2 DJ setups until I found their Cruise (autoplay) mode was just scary (it takes your channel faders to 100% immediately) and that was a deal breaker. Imagine my surprise to find MixVibes smartlists handled natively instead of relying solely on iTunes and that whole cluster of problems when it comes to sorting large iTunes smartlists. I've also been eyeing a couple other features in your software that I am dying to try out in public and see how they integrate with our workflow,,,,
