MIXVIBES Dj Community old forum

Hello,
I have a SDJ100 a1, bought at Lidl.
I connected it to my laptop and it works.
My problem is that I also have a Creative SB1090 xfi usb sound board and want to create the folowing setup:
for preview and sync to hear trough my headphones
for play to use the creative board.
The fun part is that trough direct sound i can see the devices but when i want go to dual sterea, I only have output 1, no other posibility to use output 2 and setup to another soundcard.
Plese help me into figuring this out.

Regards,
George

goggle asio 4 all ,, ,, read instructions and install ,,for win systems ,, didnt see your os ,, if mac then google aggreat sc set up for mac ,, ,,will post later with more info or answers to

Hello,
With ASIO4ALL i get a lag.
I have a windows 7 OS.
Isn`t possible to get the setup without ASIO?

if the sb card is a multi channel sc then if its not reconized as such in Cross then asio will and give use to the outputs ,, ,,
using the headphone from computer and using a second sc ,, will have lag because of the clocking /different sc ,,
you realy need a multi channel sc ,,

It is a multichannel sound card.
I will try this tonight.
Thank you for your help.
Regards,

the more info and screen shots the better ,, late for me also ,,

The ASIO driver allows for lower latency of the soundcard than the WDM drivers. If you have dropouts you should increase the latency. Try to use lowest possible latency; but don't push it to the limit.

As Daniel mentioned some screen captures can be very helpful to support you.

Hi . I also have a SDJ100 a1 , i have a PC with a 5.1 soundcard . and i also have an onboard soundcard witch is also 5.1.
I have Asio4all installed but i still cannot use my onboard 5.1 card as a a CUE .
I set the Cross DJ application to double stereo but the music is playing inalso on my onboard and my PC s soundcard...what sould i do ?

Please reply thanks

You have to set the Asio4all to use multiple outputs.
Then in Cross you can select the output 2.

For the asio settings: open the control panel, switch mode in the pop up to allow selecting multiple channels.
Only activate channels you use, as every channels consumes CPU power.
Options are depending on driver and sc. Some allow enabling in detail, others only on/off for the whole sc.

If this doesn't help you, please provide 3 screenshots
- asio4all menu
- Preferences | audio tab
- overall GUI
By this we can see likely see if it is a setting and/or a control issue

Thx RoJeC for the quick reply.
I attached my asio 4 all settings, but the rest of itt i don`t know where to find them can you please describe them where can i find them ?

Thank you very much for your patience.