MIXVIBES Dj Community old forum

I have separate audio/video loading checked in options but when I use the 'reload as clone of master' function it loads the video from the master into that player too.

Any way to get this function to clone the audio only?

redocoder wrote:I have separate audio/video loading checked in options but when I use the 'reload as clone of master' function it loads the video from the master into that player too.

Any way to get this function to clone the audio only?

The command already exist in the available MIDI commands under the video section.

You clone the audio only or the video only. If you are using a controller open the MIDI section in Cross and map it to the push button that you want to use for it.

Thanks a lot Fig, was using the MIDI command from the Player section.

Still not doing what I need it to do with the MIDI command 'clone audio only from Player A to Player B' in the Video section.

It's cloning the audio from the video track and not from the player that the video is attached to.

Needing to be able to clone audio only from player A to B and not from the video track.

Messing with the video locks but they seem buggy.
One side will do what I need part of the time.
Using reload as clone of master but can't seem to get the video to lock.
Is there a MIDI command for the video lock to just set it as on instead of toggle?

I see what is going on, I am cloning the same audio track and the video is locked to the track.

Is there any way to lock the video to the player instead of the track?

I am wanting to clone the audio only from one side without cloning the video. Anyone have any ideas on how to do this?