MIXVIBES Dj Community old forum

I have stanton's st 150 turntables and a djx900 usb mixer along with the u-44 audio interface .

I can get the interface to reconize the mixer , but I am unable to get any output ( sound ) from the turntables

On the calibration page the vinyl seems to calibrating but when I lift the needle the calibration goes back to zero .


I am running Cross 3.1
Stantons st 150's
djx 900 usb mixer
u 44 audio interface .

this is for anyone using stantons or other turntables .

No expert on tc, but calibrating is to tune your setup, if you intervene the process you are not calibrating; follow the manual instructions.

The tc should not produce sound out. If you want your vinyl record being routed to sound out you have select your inputs (think I noticed this in a different topic). Then in the mixer section of Cross the A or B button should be clicked on and the Deck/Line should be changed.

Please do not create different topics on the same issue, as important information might get lost for useful replies. You can bring a topic back up by replying to your own topic.

You should also make sure that from tt to Cross audio settings the signal switches are either Line (preferred) or Phono.