MIXVIBES Dj Community old forum

Cross IS OUT ?????? WHY ???????

Should I buy a new versión?

and the technical support for Cross user?

What do you mean? Which problem do you have?

Version 3.2.0 has just been released as well as a new app version..

All you have to do, if you like, is to download it...

Hope this answers your question(s)

HI!!
I use Cross for video mix.
With the U-Mix44, vinyl control DVS Ultimate and Numark TTx turntables works perfectly; but with the timecode CD and the cd players Denon DN-s3500, the master audio output is bad; I'm careful with the suggested connections of the hardware and software manual however the problem persists. Help me! Please. Thanks

can you show screen shots of your audio set up and what are the levels set at line or phono ,, little bit more info needed to help you get it sorted ,, if the vinal set up works the cdj side can be made to work also ,,just a mater of settings

I read in an another topic that we have a confirmed bug on inputs of all soundcards (mac version) just wait before a soon come corrected release 3.21

OK !!
thank you very much for the information.
I use PC versión and the volumen panel driver 1.0.4 for the U-MIX44, but I'll wait the corrected release as you say. However I thank for any additional suggestions.

chemodj wrote:HI!!
I use Cross for video mix.
With the U-Mix44, vinyl control DVS Ultimate and Numark TTx turntables works perfectly;

but with the timecode CD and the cd players Denon DN-s3500, the master audio output is bad;

I'm careful with the suggested connections of the hardware and software manual however the problem persists. Help me! Please. Thanks

Dont use DVS and timecode ,, but what are the input levels set at when you are using the turntables and t c and what is the level set for when you use the cdj and t c ,, i have to read the manual too see if there set differently

Using the turntables and vinyl timecodes the level set in the volumen panel of the U-mix44 is: input 3 and output 3.

Using the cd players and CD timecode: input 1 or 0 and output 1, but the master output never performed an improvement.

Note: the indicator leds input in the U-mix44, using vinyl timecodes remain OFF; using CD timecodes remain ON (as saturation sound) though I set the level input in 0 in the volumen panel and "Line in" and "CD MV" in the audio configuration