MIXVIBES Dj Community old forum

It has been awhile since I was last on the board i have several questions that I need help with :

1. I am going to be using stanton st150 turntables with a Behringer djx900 mixer do I need the mixvibes audio interface box .


2. where can I get another copy of Cross DJ 2.5.0

DJPOLITIC123 wrote:1. I am going to be using stanton st150 turntables with a Behringer djx900 mixer do I need the mixvibes audio interface box .

You will need Cross for this. CrossDJ does not support timecodes. Almost any 4in/4 out ASIO sound card will work.

DJPOLITIC123 wrote:2. where can I get another copy of Cross DJ 2.5.0

Try here

downloads.php?cat=86

When I buy Cross How do I get the software to read all and pull in all 10k plus songs from iTunes ?

Go to the iTunes node in Cross and drag tracks to collection...

Cross can use the same collection as Cross DJ. So you might want to use that.

Ronald do you mean that I have to drag each song individually ? or as a whole collection ?

Anything between 1 and all at once....
You have Cross DJ, so you can try before you buy... Works the same.

if you are using iTunes to organize your tracks, you can go to the iTunes node and drag the playlist to the collection. Cross will ask if you want to merge it or replace it. or you may want to drag the iTunes icon to the collection once again.

It will keep all the track that you had and add the new ones.

Note that for this to work correctly iTunes must be closed before you perform the update in Cross. Otherwise Cross can't grab the information as it is locked while iTunes is still open.

RONALD will I need the u-44 audio interface box with my new set up ( stanton's 150's and the Beringher dx900 ?

If I found right model (using small smartphone screen) then the mixer has tt inputs. If these are available in the soundcard driver you can use these. Same applies for outputs.
Also here applies that you should have the out/inputs in the audio tab in Cross DJ already.

:cool: Cross DJ doesnt use tc signal ,,

if you dont have this tab in preferences ,, you will need Cross to run t c signals to the software