MIXVIBES Dj Community old forum

HI!

cd-mode jogwheels are very agressive, so if i use Vinyl-mode, where sensitivity is in the middle and choose cd-mode, and try to adjust speed with jog, the moment i touch, the moment it stops, so it's really sensitive.. if i turn sensitivity to minimum, then it's ok, but i can't use Vinyl mode without changing senitivity... is there some kind of trick to fix this?

and one more beauty thing, leds on jogs dont show lights.. this is probably small thing to fix?

Thanks,
Aivar

sounds to me that you have the DDJ SX still set to serto mode and not MIDI mode. it's in the manual how to change it.

turne of the DDJ SX and disconnect the USB cable

press shift + Play and hold it while you turn on the DDJ SX when all leds stop flashing spinning. make sure the left key lock is turned on to set it in to MIDI mode when LED is of it is in Serato mode. then turn the DDJ SX back of and plug in start should fix you problems with Jog wheel

Thanks, it did work!

aivar00 wrote:HI!

cd-mode jogwheels are very agressive, so if i use Vinyl-mode, where sensitivity is in the middle and choose cd-mode, and try to adjust speed with jog, the moment i touch, the moment it stops, so it's really sensitive.. if i turn sensitivity to minimum, then it's ok, but i can't use Vinyl mode without changing senitivity... is there some kind of trick to fix this?

and one more beauty thing, leds on jogs dont show lights.. this is probably small thing to fix?

Thanks,
Aivar

It sounds like you haven't set up your controller for use with "other than Serato" software. Take a look at the MIDI map release document page 1 on the Mixvibes website and pages 23-26 on your controller's owner's manual.