MIXVIBES Dj Community old forum

has anyone successfully mapped the new NI Kontrol F1? if so can u PLEASE share the mapping file... ive mapped most of it but having problems

Hi djhatch,

why dont you tell us where you have problems?
I am sure you will be helped


Best regards
Marxon

ok... lol... for starters.... so far so good with mapping the F1... my first problem.... the push buttons at bottom of F1 are preset in Cross mapping as fader/knob... due to this i can map them to mute on but they will not toggle back to mute off because they preset as fader/knob... i used Native Instruments Controller editor to map the buttons as actual buttons instead of faders but when i get back to Cross they are once again back to fader/knob preset.... a problem so small yet driving me insane please help me... im only a beginner at mapping..

djhatch wrote:ok... lol... for starters.... im only a beginner at mapping..

have you looked at the instruction in the manual about setting up a editable mapping for Cross ,, seems like the changes you are making are not getting tranfered to Cross ,,
i am not even at the begining stage my self ,,

is it a possibility that the physical nature of the control cant be changed from a fader to a on/off toggle
a little bit more info as to the exact mapping knob you are trying to change ,..and maybe some screen shots of the changes you are trying to make

djhatch wrote:ok... lol... for starters.... so far so good with mapping the F1... my first problem.... the push buttons at bottom of F1 are preset in Cross mapping as fader/knob... due to this i can map them to mute on but they will not toggle back to mute off because they preset as fader/knob... i used Native Instruments Controller editor to map the buttons as actual buttons instead of faders but when i get back to Cross they are once again back to fader/knob preset.... a problem so small yet driving me insane please help me... im only a beginner at mapping..

I've been trying to map the F1 Z1 and X1 mk2 I have no problem mapping them only I can't get any of the LEDs to work.
You might want to go into the Controller editor from NI and change your buttons from CC to Note that way they can be mapped as buttons in Cross.

that solved my problem.... had to go change some things in controler editor and now it works... if anyone reads this thread and has the Kontrol F1 led's mapped can u please please contact and share the file with me plz