MIXVIBES Dj Community old forum

Hi,
I have been trying the integration with the cdj's 2000 but is crash a lot of times...to been able to run 2 of them i need to install the asio4all...
And routing the sound...is a nightmare....by the way the sound seems a little bit "unprofessional"....still preferring using the time codes and the sound card...the connections is much easier (despite the mess of cables) and the sound is better...
I could provide more help...i work on a club as resident DJ...and my setup are the cdj's 2000 and djm 2000...

what version are you running of Cross,,the updated version 2.3 should have new features that help with poineer intergration,, check out the realese notes ,, also any other in that will help you figure it out please post for thoes who know

The 2.3.0 the latest update....i.post this to report this bug...

not familiar with updated ver and also cdj s so any info as to whats going on with this please post so as to be able to figure it out ,,

Di Rossi wrote:Hi,
I have been trying the integration with the cdj's 2000 but is crash a lot of times...to been able to run 2 of them i need to install the asio4all...
And routing the sound...is a nightmare....by the way the sound seems a little bit "unprofessional"....still preferring using the time codes and the sound card...the connections is much easier (despite the mess of cables) and the sound is better...
I could provide more help...i work on a club as resident DJ...and my setup are the cdj's 2000 and djm 2000...

Check your CDJ's firmware is up to date.
Use the Pioneer ASIO driver instead of Asio4All.

- you need to use the Pionner drivers to do the agregation
- update decks to latest firmware
- select the advanced HID into the CDJ menu

You've got early CDJ2000 (not Nexus) ?
How do you connect the CDJ to the computer ? (direct or active/passive
hub)

We have tested all combination of decks by pair, crossed for months and never felt into this issue.
CDJ : 350/400/850/900/2000/2000NXS

I had no problems with cdj 2000 and Cross.
use hub with and without him.
The problem is with Cross or CrossDJ?

gone try to answer every question..
only test the Cross (i also have the Cross DJ,but i'm not use)...
Yes is the 2000, not the nexus edition....i have the latest firmware from pionner, 2.04 i think, i now is the latest.
I already try many ways and in deed is working but crashes a lot..
Not sure about the advance HID, but i almost sure that is on advance mode....have to check out....
Thank for the help...i report this because i want Mixvibes at the top of software....really love the program....and despite i have all of major djing softwares, i can just play and don't change Cross for anything...

Just to prove that
https://www.youtube.com/watch?v=FXd6Ke2 ... Behpj0Dwgg

what is the computer configuration?
This latency in which? 128, 256 or 512?
You have selected asio driver Pionner in Cross?
You have selected external mixer in Cross?

cas41532 wrote:what is the computer configuration?
This latency in which? 128, 256 or 512?
You have selected asio driver Pionner in Cross?
You have selected external mixer in Cross?

Depend....on timecodes i use normally a 192 sample rate to 4.4 mls or a 128 for 2.2...all run pretty fine....i have an i3 2.4 with 4 gb ram...
I have try with every layouts of routing...by the way i can't select the asio because the Cross detected the driver as a direct sound...