MIXVIBES Dj Community old forum

Thanks to feedback from forum, I have my system sounding great.

I have played with the the functions of the PRO controller and like it so far.

What I cannot figure out yet is :

How do I listen to the CUE track while one is playing on speaker system.

I have the properties set to Stereo, and have tried using the other
settings as well.

I have my headphones connected to front connection, and have tried both sizes (should not matter, but just testing)

I have selected the Phones button on the controller CUE track side, but, I still here
the track playing on the speaker system in my headphones as well.

I have tried moving the knobs next to headphones connection inmultiple ways, but, cannot get the CUE track in my headphones.

There is a small piece of text in the book I received, but, I try to follow it and still cannot get this to work.

Is there a button combo I need to use to listen to CUE track in headphones while playing another track on speaker system?

Thank you.

Hey,

use DUAL STEREO and set output 1/2 to master and output 3/4 to CUE and you should be able to hear the sound through your connected headphone when enabling the cue function in Cross (DJ).

regards
Christian

Additional to where you can enable the headphone use this buttons in Cross DJ: (red labeled)

use DUAL STEREO --
I undersatnd how to do this

and set output 1/2 to master and output 3/4 to CUE --

I do not undersatnd how to do this.
can you explain in detail?



Thank you for the help.

Hey,

I will do some pictures. Let me a few minutes to start my notebook and then I upload them.

regards
Christian

So here is the picture:
It is with my U46MK2 but you have to do this with your internal card of the U-Mix Control Pro but it is like the U46.

Set Output 1: U-Mix Control Pro Output 1/2
Set Output 2: UCMP Output 3/4 (which will also be the headphone)
Set it as the picture and then you should hear the headphone (maybe set the volume level higher to get sound)

regards
Christian

that is exactly what I needed to see.

I will try this tonight.

Thank you again for the help.

I have changed the settings and still cannot do this.

I also tried moving the outputs: with new properties
both on 3/4 side
both on 1/2 side
white on 1/2 side
red on 3/4 side

does not work as needed.

what I am doing:

load track A
load track B
play track A
source A head phone button not highlighted

song plays on system.. good.
same song plays in head phone.. ok

push source B head phone button now is highlighted
hold down cue

both source A and B plays on system.
both source A and B plays in head phone.. bad

I want to only hear source B in head phones at this point.
and source A on system.


Thank you for your help.

are you shure you selected "dual stereo" ?

I'm positive.