--Solved-- U-Mix Control Pro audio setup

[gman]

Thanks to feedback from forum, I have my system sounding great.

I have played with the the functions of the PRO controller and like it so far.

What I cannot figure out yet is :

How do I listen to the CUE track while one is playing on speaker system.

I have the properties set to Stereo, and have tried using the other
settings as well.

I have my headphones connected to front connection, and have tried both sizes (should not matter, but just testing)

I have selected the Phones button on the controller CUE track side, but, I still here
the track playing on the speaker system in my headphones as well.

I have tried moving the knobs next to headphones connection inmultiple ways, but, cannot get the CUE track in my headphones.

There is a small piece of text in the book I received, but, I try to follow it and still cannot get this to work.

Is there a button combo I need to use to listen to CUE track in headphones while playing another track on speaker system?

Thank you.

[christiankoopmann]

Hey,

use DUAL STEREO and set output 1/2 to master and output 3/4 to CUE and you should be able to hear the sound through your connected headphone when enabling the cue function in Cross (DJ).

regards
Christian

[christiankoopmann]

Additional to where you can enable the headphone use this buttons in Cross DJ: (red labeled)

[gman]

use DUAL STEREO --
I undersatnd how to do this

and set output 1/2 to master and output 3/4 to CUE --

I do not undersatnd how to do this.
can you explain in detail?



Thank you for the help.

[christiankoopmann]

Hey,

I will do some pictures. Let me a few minutes to start my notebook and then I upload them.

regards
Christian

[christiankoopmann]

So here is the picture:
It is with my U46MK2 but you have to do this with your internal card of the U-Mix Control Pro but it is like the U46.

Set Output 1: U-Mix Control Pro Output 1/2
Set Output 2: UCMP Output 3/4 (which will also be the headphone)
Set it as the picture and then you should hear the headphone (maybe set the volume level higher to get sound)

regards
Christian

[gman]

that is exactly what I needed to see.

I will try this tonight.

Thank you again for the help.

[gman]

I have changed the settings and still cannot do this.

I also tried moving the outputs: with new properties
both on 3/4 side
both on 1/2 side
white on 1/2 side
red on 3/4 side

does not work as needed.

what I am doing:

load track A
load track B
play track A
source A head phone button not highlighted

song plays on system.. good.
same song plays in head phone.. ok

push source B head phone button now is highlighted
hold down cue

both source A and B plays on system.
both source A and B plays in head phone.. bad

I want to only hear source B in head phones at this point.
and source A on system.


Thank you for your help.

[Hannes]

are you shure you selected "dual stereo" ?

[gman]

I'm positive.