MIXVIBES Dj Community old forum

i have the ion discover DJ pack, have installed Cross and then found out on here i need a usb sound card which i now have. then i found out i needed asio4all which i downloaded. when opened it has my usb sound card and it selects fine but my other audio output which is called HD audio rear output 2 when selected says beyond logic?? now what? i can select asio on the audio options on Cross and then select my usb device in one of the outputs but the hd audio is not there? any help appreciated, cheers
dan

heres a print screen

Hey,

I'm not an asio4all specialist and have only worked one time with it but to my knowlege you have to combine both audio devices to a virtual soundcard at asio4All. you can pair two outputs of different cards and then Cross DJ can see at Asio4All the two devices as different outputs.

How it exactly works can maybe say someone how is working with it or you look at the internet for some tutorials.

regards
Christian

just curious what os are you using is the software seeing the installed sc and routing signals to it,,,what are the info on the installed sc and is the routing in the comp correct,,in the tab where you select asio4all what are the other selections just to find the answer and a solution

im using xp. i can play music though the HD sound card in Cross, iTunes and anything but cant get it to select the option in asio!

have you downloaded the instruction and faq from the asio 4all site , gives a little bit more info maybe alittle bit helpful, was looking at it just now,,there is a section on troubleshooting and they do list a fault beyond logic , maybe some help...have used asio4all in many config you have to tweek on it and sometimes still not the best solution,,,

couple of more are you running any thing else in the background and any thing to do with the sc can you get asio 4all to run just the installed sc,, or still beyond logic use vista my self and had limited success , other issues with sc clocking and sound delay/lag,, can you set the ferquency, sample rate to the next tab to the right and try,,think its 4400

correction its 4800,, also just another thought is to reset default setting in asio and start from there to see what works/doesnt work

yes asio runs with Cross but nothing else is running but it thinks it is, is there a way to disable sounds except via asio? im a bit new to all this so quite slow, im good with computers but never tampered with stuff to do with sound so all new to me!

have you look ed at the instruction manual for asio4all,, have you set the sample rate to 48000,, have you set the default settings and re activated the sc selections you want to use you cant break any thing by playing with the settings , cant see what you have tried /what not working,,info as to what you have tried and the outcome

if you hit the drop down tab where there i none selected are there any choices

if you close and reopen Cross does it change anything