Page 1 of 2

Vfx help

PostPosted: 27 Aug 2011, 17:57
by FileSpnr
I installed the Vfx software.
When I open the software, the Vfx controller shows in the MIDI list.
I set the soundcard to Vfx.
I get no functions from the controlle,r and no sound either.
I turn on "info"
The message at the bottom of the screen reads
midi1-ch16#9f722(NOTEON 127 34) Command=FIRMWAREVERSION

moving controls on the device does not change this message

Re: Vfx help

PostPosted: 27 Aug 2011, 18:00
by Blackbrook
Did you unplug und plug it in again? Did you reboot your machine? Is it activated in the MIDI tab of the preferences?

Cheers,

Steve

Re: Vfx help

PostPosted: 27 Aug 2011, 18:14
by FileSpnr
Ok I have it running nw.

So the power button being NOT lit up is when the device is on? Is that correct?

I was thinking the Blue light meant ON :rolleyes:

What worked was pressing the power button aftre the softwrae was running. Does that sound correct?

Re: Vfx help

PostPosted: 27 Aug 2011, 20:30
by Blackbrook
Yes that is correct! Blue power button means offline and if the row of red and yellow lights are running from one side to the other then it is in "stand by" mode.

Cheers,

Steve

Re: Vfx help

PostPosted: 27 Aug 2011, 22:12
by FileSpnr
I have another issue.
I installed and ran first on Win 7 pro 32-bit, all ran well

I then installed on Win 7 pro 64-bit, and the left jog wheel works properly, but the right jog wheel releases the track while I'm touching the jog.

Any suggestions?

Re: Vfx help

PostPosted: 27 Aug 2011, 23:13
by Blackbrook
Same machine (yes you can install a 32 Bit Win 7 on a 64 Bit machine)? Same mapping? Everything set up similar?

Cheers,

Steve

Re: Vfx help

PostPosted: 28 Aug 2011, 01:39
by FileSpnr
No i'ts two separate computers.

Also, now I have lost sound from the right deck.(on 64 bit)

Re: Vfx help

PostPosted: 28 Aug 2011, 11:01
by Blackbrook
Please head over to the Download Center and see if there is a driver for your Vfx Control. I know that there is one - I've had one when I was using Vfx - and maybe this is what you need.
If not then please contact support@mixvibes.com and ask for the driver (for Vfx Control MIDI Controller)!

Cheers,

Steve

Re: Vfx help

PostPosted: 29 Aug 2011, 14:09
by community@MixVibes
Hello File,

Can you give us more details, what version of Vfx software are you using, have you installed the latest software on your computer. Installing the latest version of Vfx might solve your problem!

Best Regards.

Re: Vfx help

PostPosted: 30 Aug 2011, 19:43
by djherrero
need help can pass from the stand by mode all install in win 7 no controller funsion