Conflict issues : Maya44 USB and Novation Dicers

[Hannes]

No matter of RAM but GPU.

Propably IntelGMA vs. IntelHD3000/4000 or even dedicated GPU.

[Faizel M]

@ Support MV

I just tested it the setup on a different laptop (Toshiba C650) with Windows 7 Home Basic and there is no conflict between the Dicers and the Maya Usb.

It must have something to do with the hardware of the Acer Aspire 5750Z laptop

[Support@MixVibes]

Check into Windows hardware panel what integrated hub they are using, try to put them on separate ones.

[Faizel M]

Check into Windows hardware panel what integrated hub they are using, try to put them on separate ones.

Its has Universal Serial Bus Controller : 2 x Intel R(6 Series/C 200 Chipset family USB Enhanced Host Controller - 1C26/1C2D, USB composite Device and 2 x USB Root Hub's.

I tried it seperatly and still no luck

[Support@MixVibes]

I was thinking that if they felt into the same usb hub entries there might be a conflict.

umcp_usbhub.JPG

[Faizel M]

@ MV Support,

heres a screen shot of the usb device.

[Support@MixVibes]

In the view menu, change the scheme to the "by connection" one.

[Faizel M]

Snapshot 2.jpg

[Support@MixVibes]

What devices are where ? Can you show me wich one is the Maya and which one are the dicers ?

If both are on the 1C26 then this is your issue, they both share the same usb adress.

[Faizel M]

What devices are where ? Can you show me wich one is the Maya and which one are the dicers ?

If both are on the 1C26 then this is your issue, they both share the same usb adress.

I will post a snapshot later but that is exactly the problem - irrespective where I plug the usb into.(seperate usb's)

How do I remedy the problem. Can I uninstall the usb drivers and re-install them?