3rd Output

[sfronti]

Last night i was trying to configure the 3rd output of my soundcard and use it for my monitor but i could not find a way. Is there something that i am missing? I configure my outputs as usuall (1-2 master, 3-4 headphones and 5-6 monitor) but i didn't get any sound.

Thanks a lot
Stelios, Greece

[RoJeC]

Not sûre if it can but what audio mode do you select.

[daniel clark]

screen shots of your audio config ,,might give a better picture and info on how you are trying to listen to the 3 rd output ,, need info

[sfronti]

Νέα εικόνα.jpg

Here's my Audio settings. In previous versions of Cross (1.5x) i remember i could drive a third output as monitor.

Thanks a lot

Stelios, Greece

[daniel clark]

in the drop down menue chechk out the possibilities ,, your screen shot shows it as dual stero ,, look like its one of the later versions so there should be a selection fo what you need ,, ,,wish it was a re wire option there to be able to tailor the sond confif to your liking /needs , hope this helps

[Blackbrook]

Dual Stereo is for two outputs max. Check the other possibilities mate ;-)

[RoJeC]

'External Mixer Cue' uses 3 outputs.

[sfronti]

I'll check it right away!!! Thanks!!!
The good thing is that blackbrook is back!!!!

Stelios, Greece

[daniel clark]

Thanks!!!
The good thing is that blackbrook is back!!!!

Stelios, Greece

we feel that way also

[sfronti]

No it's not working with 'External Mixer Cue' too. Also, using this routing mode is disabling Cross's mixer. I am using a MIDI controller so the mixer is necessary. i will install Cross 1.5x and check it.

Thanks a lot

Stelios, Greece