Cross 1.3.2 and fa101

[gakto2009]

ok, so hears the deal...

when i try use the fa 101 with Cross 1.3.2 and config the channels to run with the setup, i must have a third output selected... why?

not only that, i must select the third output first, then the first output.. and finally the second output. if i dont do it in that order then only player B works though output 1.

EDIROL FA-101 Driver Ver.1.0.0 for Windows® 7 32-bit Edition

[gakto2009]

little update for ya...

after i use Cross, my Producer doesn't work right... seem to get a really high latency. i need to reinstall the driver again for it to work properly.

BUT

after i use Cross again it does and a reinstall is needed to get Producer working again..

booooooooooooo

[Support@MixVibes]

So are the drivers the problem ?

[gakto2009]

So are the drivers the problem ?

doesn't seem to be a problem with the driver, a can go between other softwares fine, and even run them at the same time... its only when i try and use Cross with the driver that it all falls down and starts to cry.

[Support@MixVibes]

May be Cross and these drivers don't want to make friend...
Can you try with asio4all to see if it act the same please ?

[gakto2009]

Ok, ill get right on it and see what does down in the ghetto...

[UncleVibes]

windows 7 no problem (no crash) with my fa101 but there is still a problem with the inputs / outputs

[hemskoc]

Some extra info, it works fine on fa66 swapping between DVS7 and Cross. No channel selection problems (i know u got more ins and outs, but just sorta to prove the standard Roland driver works fine...)
< WIN xp 3>
Cheers

[Dj NB]

work just fine with rme 400

[Alek]

Hi !

I have a little bug with Cross 1.3.2 and my FA-101 too.

Here you can see how I had to configure Cross to work well with my soundcard.

Nothing very important because everything work so well but I just want to report it.
I have already checked my hardware connection and everything is ok.
Moreover, everything is well configured on my MV Producer. Line IN 3 & 4 of my Player 1 go to Line OUT 3 & 4 on first audio OUT in FA-101 setup, etc.

I encounter some bugs with my FA-101 too. It needs to be restarted sometimes to work. Next time,I will try to start it after my Windows...
I am not sure that is it cause to Cross. Perhaps my laptop need to be formated, a little bit emptied...

I hope you understand me.