Cue volume shadow mapping wont latch to MIDI control

[Nutty667]

Hi.
I have a Xone K2 connected upto Cross DJ, and I'm using some "mixer" pots to control the cue/mix knob on the top right part of Cross.

The problem is, when I turn the knob on the Xone, when it lines up the shadow point to the actual point in the software it doesn't lock on. Sometimes the software position will move a bit, but becomes disconnected from the MIDI position. Seems that I can mostly move it up, but when I try and turn it back to the left, the software position doesn't follow the MIDI position.

The issue doesn't happen with the Cue knob to the left of it.
This is 3.3.3 64bit.

[Nutty667]

If I swap the cue onto another MIDI knob, the problem isn't as bad but its still there.

Also this doesn't seem to happen as much on my AMD desktop, just the Intel laptop.

Happens in 3.3.3 32bit as well, but 3.2.0 works fine.

[Nutty667]

Bug still occurs in 3.3.6 64bit.
Here's a video of it. Watch the Mix knob as I adjust it on the K2.

https://www.youtube.com/watch?v=VpkOfdF ... e=youtu.be

[Nutty667]

This seems to be fixed in 3.3.9

[Nutty667]

Spoke too soon. After getting down to a proper session, this still happens on the cue/mix knob.

[RoJeC]

Does it work when turning really slow.
I have such with my Mix button. It wouldn't be the solution but might help to find the real problem.

[Nutty667]

You can "manage" the issue by turning the knob at various speeds past the shadow point. Sometimes it takes a while to get it though.

Not what you want when you just want to turn a knob and have it work without looking at the screen though.