Cross DJ Sampler pads 8 V Mixvibes Producer Sampler Pad 16

[DJ911 PRODUCTIONS]

Question how can you link Cross DJ Sampler pads 8 on each deck to play like trigger pad sampler with 16 pads including player track ?
Example: Mixvibes Producer Sampler Pads 16 like trigger pad also use sampler with track player.

[daniel clark]

kinda remembering the sample pads in home ,,similiar to the set up in Producer ,, are you asking can you trigger all of the pads to play out of master out put ,, regardless of where the c/d crossfader is at

[daniel clark]

Offtopic.HorsSujet!

You might want to put your Cross software licence key in your profile

[FigDJ]

You can de- select C and D from the crossfader assign. These are buttons on each side of the crossfader. Doing so will make the sampler pads play out in master output regardless of the crossfader position.

[DJ911 PRODUCTIONS]

Can you send me a mp3 sample or wave sample so I can hear it work ?
I am seeking to trigger samples with MIDI pads like a one unit 16 pad sampler with track player sequencer e.t.c... like M-audio trigger finger or korg kontrolpad.
I do not want to have to trigger sample separately on each deck.

[RoJeC]

If you have Cross (only did not register the key yet), you will likely have samples with the install.

What I do not understand (for sure) is what you want to do.
Triggering samplepads from the samplerdeck in Cross can be done by setting the MIDI mapping accordingly; this is simple to do, for any MIDI device.

But if you want to start multiple commands at once you need FigDJ to explain if this can. E.g. if you want deck A Play command to also trigger Sample deck C-pad 1 in one button click. This will be more challngeing as starting is one, but stopping it is another challenge, unless it may be in sync.

[FigDJ]

You can certainly map a controller to trigger multiple commands at the same time. Need a detailed explanation of what you want to do and how exactly you want the sampler to behave. Yes you can trigger samples pad with the deck transport controls, just need to map the desired behavior. Also the slicer functions may come in play depending on the size loop you have selected.