DelayWithMaster

[Marxon]

Hi all,

does anybody know how to use the DelayWithMaster output?
It sends 64 if the player is in sync with master and
rises up to 92 if the player is 2 beats behind/after the master.
What needs to be done, that it uses the full resolution from 0-127?


Best regards
Marxon

[Marxon]

...I forgot to show, how i actually mapped it:

Code: Select all

<mapping>
<control alias="fam(Player)[0x1].DelayWithMaster" value="%"/>
<MIDI type="CC" parameter="0x01" channel="0x01" value="%"/>
</mapping>

[sylMV]

DelayWithMaster is quite tricky and unfinished command...

Only the [0.5 1.0] range is used ([64 127] in MIDI) and represents how the deck is delayed compared to the master. The [0 63] had been reserved for negative delays but never used till now...

I need to check (it's been a while I made this ^^), but I guess there's no possibility to "change" the range, sorry.

[Marxon]

64-127 would be no problem,
I can adapt my Controller...
But i never get values greater 92
Strange
Will the delaywithmaster alias ever be completed?
Or anything similar?

[sylMV]

But i never get values greater 92
Strange

Strange indeed, i'll have a closer look on monday.

Will the delaywithmaster alias ever be completed?
Or anything similar?

Don't think so, in a short time...

[Marxon]

Strange indeed, i'll have a closer look on monday.
...

Thanks

Don't think so, in a short time...

thats bad because it would be a very usefull feature

[sylMV]

thats bad because it would be a very usefull feature

Let me know what you would like to do with and I'll see what I can do during coffee break

[Marxon]

Let me know what you would like to do with and I'll see what I can do during coffee break

Thanks again, but it would be enough if delaywithmaster does what it suggests.
OK this might be better:
Two values for each player, which behave just like the two colors of the sync circle.