Cross skipping while mixing

[Support@MixVibes]

Did you use the CDJ350 with its own soundcard or with the U-Mix44 ?

last sunday i tried HID mode with cdj350 & Cross 2.40
i never had that skips in 5hrs set. the only thing i've notice in HID mode is when the cdj350 pitch goes to 0 sometimes the pitch control will stuck to 0, you need to move the slider back to 0 to make it work.

i've also seen that pitch control stuck issue with american DJ vms2 but it's worst in vms2. can you please check that pitch control issue with vms2?
i tried to use the 2.6 firmware for vms2 but it has same problem with the pitch.

The pitch issue you're talking about is the MIDI takeover to avoid jump.

[DJSUB]

Did you use the CDJ350 with its own soundcard or with the U-Mix44 ?

last sunday i tried HID mode with cdj350 & Cross 2.40
i never had that skips in 5hrs set. the only thing i've notice in HID mode is when the cdj350 pitch goes to 0 sometimes the pitch control will stuck to 0, you need to move the slider back to 0 to make it work.

i've also seen that pitch control stuck issue with american DJ vms2 but it's worst in vms2. can you please check that pitch control issue with vms2?
i tried to use the 2.6 firmware for vms2 but it has same problem with the pitch.

The pitch issue you're talking about is the MIDI takeover to avoid jump.

i use cdj350 soundcard

[Support@MixVibes]

And if you use the CDJ with the U-Mix44 does the sound skip ?

[DJSUB]

And if you use the CDJ with the U-Mix44 does the sound skip ?

yes with Cross, but with traktor i never had skips.
only in HID mode Cross works fine for me.

last sunday is my 1st time to run Cross in HID mode, i never had that skip in 5hrs set. i will try & observe it again this coming friday then i will report back.

i want to use Cross in my gigs because i know Cross is better than traktor & serato but how can i show it if i have skips with u-mix44?

hope someone could help me fix that issue

thanks

[Support@MixVibes]

What latency are you expecting with the U-Mix44 ?

[DJSUB]

What latency are you expecting with the U-Mix44 ?

i was expecting atleast 11.6ms (Buffer size :512 samples) works fine with tracktor.

i set mine @ 768 Buffer Size : (17.4ms) upto 960 (21.8ms) in Cross
44100hz

and my audio cache set to 50-60% of my 8gb ram

[Hannes]

if you go lower?
maybe the CPU is clocking down because there's too little load on it...

[Support@MixVibes]

256 / 192 / 128 are more standard values used with the U-Mix44 and with no issue at all.
I don't remember what drivers have been mentionned : Asio4all or MixVibes ?

[DJSUB]

256 / 192 / 128 are more standard values used with the U-Mix44 and with no issue at all.
I don't remember what drivers have been mentionned : Asio4all or MixVibes ?

i think it's asio4all

[Hannes]

Try the Mixvibes Driver...